Skip to content

Del Monte Forest Placard Holder Installation Guide

YOUR KIT

  • Qty 1 – Aluminum anodized Placard Holder w/pre-tapped 10-32 holes for mounting the DMF Placard
  • Qty 3 – 18-8 Stainless Steel Button Head Hex Drive Screws, 10-32 thread, 3/16″ Long
  • Qty 3 – 18-8 Stainless Steel Split Lock Washers, Number 10 screw size
  • Qty 1 – Hex L-Key, 1/8″ Size
  • Qty 2 – Nylon Spacer, 1/2″ OD, 1/8′ Long (spacers for decorative license plate frame)
kit2

WHAT ELSE YOU MIGHT NEED

  • Screw Driver
  • License Plate Screws

STEP BY STEP PICTURE INSTRUCTIONS

   STEP 1 | LOCATE HOLDER SCREW LOCATIONS

step1_Pre_Threaded

   STEP 2 | MOUNT PLATE

STEP 3Use Split Washer

   STEP 3 | TIGHTEN WITH ALLEN WRENCH

step4Tighten Snug

   STEP 4 | PLACE WASHER BETWEEN HOLDER & LICENSE PLATE

step 5Nylon Washer Spacer

   STEP 5 | WASHER PLACEMENT

Washer Use to fill gap

   STEP 6 | VERIFY HOLDER POSITION

step6Washer spaces frame off of extension

   STEP 7 | CHECK LICENSE PLATE SCREW LENGTH

step7License Plate Mounting Screws

   STEP 8 | MOUNT LICENSE PLATE

bmw3

INSTALLATION COMPLETE